How to Keep a Pool Cover On

Pool covers are an import element in protecting your pool. It is important to select a cover which meets your needs. Pool covers are generally available in different types from a solid tarp to mesh. Regardless of the cover you choose, if it doesn't remain on the pool it won't do it's job. Here's how to install a cover.

Supplies

• Measuring tape


• Pool cover


• Winch


• Deck brackets


• Drill


• Screws

Above the Ground Pool

1. Measure your pool.


2. Purchase a cover. The cover should be at least four feet greater in length and width of your pool.


3. Pull the cover over the pool. Fold the edges of the cover over the sides.


4. Lace the cable provided with the pool cover through the cover's grommet system.


5. Use the winch to tighten the cable and pull the cover down securely around the pool's sides.


6. Tie the cable when the cover is tight. This will prevent the cover from being blown off during high winds.


7. Remove the winch.

In Ground Pool

1. Measure the pool with your tape measure.


2. Purchase your cover. The cover should be four feet wider than the length and width of your pool.


3. Use the drill and screws to install the recessed deck brackets, which will serve as cover anchors around the perimeter of the pool.


4. Place the cover over the pool. Make sure the straps each correspond with the recessed deck brackets.


5. Thread the pool cover's built in straps through the deck brackets. Since each strap is attached to a spring, which tightens the cover to a taut position when installed on all perimeters, the cover remains securely in place even during excessive winds.