Plumbing and Drain Tips for Bathroom Installation

When installing or renovating a bathroom, one of the most important aspects is the drain. An improperly installed drain may back up waste into the bathroom. The drain is subject to wear and tear due to frequent and heavy use. Clogging occurs from time to time. If the drain is installed properly, unclogging drains should be a simple task.

Building Regulations

Find out the building regulations required for the plumbing job and follow the codes. You will need to follow the set standards in the materials and design you use. Visit your local building regulation office to apply for a permit, if necessary. Your project will pass inspection only if you follow the rules.

Use the Correct Equipment

Using the right equipment is a vital factor in drain installation. Before making the purchase you have to make sure that you get good quality supplies that are up to code. The right equipment will include the drain itself as well as the drain assembly, the P-trap, a swivel connector, putty and glue. DIY kits containing the materials can be purchased in most hardware stores. It is important to make sure that the kit has all the parts before installation.

Follow Instructions

Follow correct instructions when installing the plumbing. If you are unsure of the steps to follow, consult a professional plumber. Most of the work is easy to do but the right process must be followed. Ensure all the gaps are sealed to prevent water leaks. Check all the pipes to ensure that they fit properly. Measure the area before installation, and make sure the length of the pipes is correct.

Inspect the Work

Check to make sure that the pipes have no leaks before you install the connections permanently. Run the water through the pipes and if there are no leaks, apply glue to hold it all in place. You may also need to use cement to prevent it from loosening in the future. Hold the installation in place for a few minutes to make sure that the glue or cement sets properly.